德國MR CHEMIE清潔劑MR85產品描述 外觀及組成： 基于醇的溶劑混合物，符合EN ISO 3452-1. 慢干 閃點材料+13°C 適用于所有金屬（用于塑料時需要在使用前進行測試） 處理溫度-10至+50°C General appearance and composition: Mixture of solvents based on alcohol, method C according to EN ISO 3452-1 Dries slowly Flash point material +13 °C Suitable for all metals (suitability for plastics needs testing prior to use) Processing temperature -10 to +50 °C Aerosol can overhead sprayable
MR CHEMIE清潔劑MR85應用： 首先以合適的方式去除物體表面的火絨，銹和其他污染物。 您可以使用MR85 Remover作為去除油脂的預濾器。通過噴涂，刷涂，浸水或浸漬將MR滲透劑涂抹在任一部位上。留待滲透至少5分鐘。然后使用干凈的無絨布輕輕地蘸上MR85清潔劑，從表面去除多余的MR滲透劑。在距離物體干燥表面20厘米左右處，均勻輕薄噴涂MR developer（例如MR70），形成均勻噴層。根據選用的滲透劑，物體表面缺陷將顯示為紅色或熒光指示。請注意：如果涂層太薄，則不會顯示。 Application: Remove tinder, rust and other contaminations from surface in a suitable manner. You can use MR85 Remover as precleaner for removal of oils or fats. Apply MR Penetrant to the part to be tested either by spraying, brushing, flooding or dipping. Allow to penetrate for at least 5 minutes. Remove excess MR Penetrant from surface using a clean lint-free cloth lightly moistened with MR85 Remover. Spray MR Developer (e.g. MR70) from a distance of approx. 20 cm on the dry surface, achieving a thin, uniform layer. Depending on the used penetrant, surface defects will appear as red or fluorescent indications. Please note: If the developer layer is too thick tiny discontinuities will not appear through the developer.
Relevant approvals and specifications Sample testing acc. to EN ISO 3452-2 and ISO 3452-6 Low content of halogens and sulphur according to EN ISO 3452-2 and ASME Code V, Section V, Article 6 In correspondence with Lloyd's Reg., Bureau Veritas, Det Norske Veritas, admitted by Framatome ANP Produits et Matériaux Utilisables en Centrales (PMUC)
zui短保質期： 室溫下至少4年 包裝規格： 氣霧式，500毫升（1箱包含12個氣溶膠） 5升，30升，200升 閥筆（笛筆） Minimum shelf life: Will keep for a minimum of 4 years, stored at room temperature Pack sizes: Aerosols, 500 ml (1 box contains 12 aerosols) 5 L, 30 L, 200 L Valve pen (Piccolo-Pen)
